Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
System Modules
TELEMAC-3D
Set different boundary conditions across the same section
Flat Threaded

TOPIC: Set different boundary conditions across the same section

Set different boundary conditions across the same section 9 years 1 month ago #21870

  • hyoukai
  • hyoukai's Avatar
Hello, everyone!
Right now, I want to build a case where there are discharges in the part near the bottom but no discharges in the part near the surface. That means I need to set two different boundary conditions across the same section. Is that possible? Since Telemac-3D builds the vertical mesh by itself?
Great thx in advance.
The administrator has disabled public write access.

Set different boundary conditions across the same section 9 years 1 month ago #21871

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3799
  • Thank you received: 1056
Hi

The actual solution is to define the vertical velocity profile which match with your needs...

Hope this helps
Christophe
The administrator has disabled public write access.
The following user(s) said Thank You: hyoukai

Set different boundary conditions across the same section 9 years 1 month ago #21872

  • hyoukai
  • hyoukai's Avatar
Thx for your kind advice. I will try this afternoon!
The administrator has disabled public write access.
Flat Threaded
Moderators: pham
Forum
System Modules
TELEMAC-3D
Set different boundary conditions across the same section

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.