Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
System Modules
TELEMAC-3D
Circular Cross-section
Flat Threaded

TOPIC: Circular Cross-section

Circular Cross-section 5 years 1 month ago #36015

  • Karki
  • Karki's Avatar
Dear all,

I would like to know if it is possible to generate the mesh having a circular cross-section for the Telemac 3D simulation.

Let's say open channel flow in a circular tunnel.

Any suggestions are appreciated.

Regards,
Saroj
The administrator has disabled public write access.

Circular Cross-section 5 years 1 month ago #36016

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3799
  • Thank you received: 1056
Hi

take in mind that the mesh definition is based on a plan mesh where you give in a second time a value to the bottom at each node.
So You could not have vertical part in your profile and you cannot represent the covering...

Regards
Christophe
The administrator has disabled public write access.
Flat Threaded
Moderators: pham
Forum
System Modules
TELEMAC-3D
Circular Cross-section

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.