open TELEMAC-MASCARET The mathematically superior suite of solvers

I am new user in Fudaa, I am using Fudaa-Prepro 1.3RC3, I tried to create new .cas file which is necessary for telemac run, when loading geometry file and B.C file this message coming, what does it means?

Thanks
AMANJ

Hi
Not sure about the roigin of this problem but i think you probably try to create a CAS file from the boundary file (.CLI) instead of the geometry file (.SLF)
Or maybe you .SLF file is wrong ...
You could try to just see it with the meshview tools or the POST tool

Hope this helps

Have you found the solution ? If yes, do you remember what was the problem ? It's been 3 years, but I have the same problem

Hi,

Actually, I couldn't find any error and as you may be noticed on the image attached above, its written in green that NO ERROR FOUND, means the message is just info and no more.

AMANJ

Here is the file of unzipped Fudaa where the same message addressed. You may follow the path and see from where this file and message code is calling inside the Fudaa code.

AMANJ