Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
PRE/POST PROCESSORS
Blue Kenue
Create file .slf and .cli in BlueKenue?
Flat Threaded

TOPIC: Create file .slf and .cli in BlueKenue?

Create file .slf and .cli in BlueKenue? 10 years 11 months ago #9217

  • thai30a
  • thai30a's Avatar
Hi everyone!
I have a question:
I read a document of "Tutorial Manual for the Mesher in BlueKenue" and make following that guide to create two file such as geometry file and boundary conditions file. But I have not file "Data_Contour.i2s" and file "Data_Bathy.xyz" that the document required.

Therefore, I use import MapInfo file (.mif) and save as ".i2s" and ".xyz" types. So, Are that using correct? If not, Can you give me two sample file as .i2s and .xyz?

Looking forward from you soon.
Thank you very much!
The administrator has disabled public write access.

Create file .slf and .cli in BlueKenue? 10 years 11 months ago #9219

  • thai30a
  • thai30a's Avatar
file attached:
Guide file: ftp://kenueftp.chc.nrc.ca/BlueKenue/Tuto...tutorial_rev0_EN.pdf
.mif file: www.mediafire.com/download/4raa7fkf2642tgj/TVAN_HT_TT.MIF
The administrator has disabled public write access.
Flat Threaded
Moderators: Serrer, a.barton
Forum
PRE/POST PROCESSORS
Blue Kenue
Create file .slf and .cli in BlueKenue?

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.