Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
PRE/POST PROCESSORS
Blue Kenue
How to specify mesh resolution in bluekenue
Flat Threaded

TOPIC: How to specify mesh resolution in bluekenue

How to specify mesh resolution in bluekenue 11 years 9 months ago #5141

  • MeshackKeabetswe
  • MeshackKeabetswe's Avatar
Hello

I am trying to generate a T3mesh. I can not figure out how to specify the the mesh computation criterion in BlueKenue. I have defined my outline, hard points and lines. Is there anyway to directly specify the desired mesh resolution? my density points are based on the bathymetry
The administrator has disabled public write access.

Re: How to specify mesh resolution in bluekenue 11 years 9 months ago #5163

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3632
  • Thank you received: 1010
Hi
the default value is given in the parameter of the mesh generator
You could also drag and drop some obects in the density layer (just take care of the values which should be strictly positive).
Have a look in the post i know there was a discussion on this subject 1 or 2 mopnth ago.

Regards
Christophe
The administrator has disabled public write access.
Flat Threaded
Moderators: Serrer, a.barton
Forum
PRE/POST PROCESSORS
Blue Kenue
How to specify mesh resolution in bluekenue

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.