open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear all,
I received this error message (below) after running a simulation. I've checked my mesh file n times and everything seems fine. My mesh, geometry file and boundary conditions are made with bluekenue.
Thank you for your help as I don't understand the source of the error.
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%

THE INPUT FILE ASSUMED TO BE 2D

THERE ARE 1 TIME-DEPENDENT RECORDINGS

ELEBD: ERROR AT POINT: 4

THE BOUNDARY POINT: 8216

DOES NOT BELONG TO ELEMENT: 0

POSSIBLE REASONS:

THE BOUNDARY CONDITION FILE IS NOT

RELEVANT TO THE GEOMETRY FILE

OR THE MESH HAS A WRONG TOPOLOGY



PLANTE: PROGRAM STOPPED AFTER AN ERROR

RETURNING EXIT CODE: 2

Without any file, kard to say more than what's written in the error message!
Check boundary point 8216

Thanks for your reply,
I took a good look at point 8216 and it seems fine.
I also resumed the mesh and restarted the simulation and I get a similar message, but with point 8086 (below). And looking at this point, it seems quite normal (see image with point of node 8086 in red).

Please find attached my mesh file boundary conditions file and harmonic file.
Thanks for your help.

%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
THE INPUT FILE ASSUMED TO BE 2D

THERE ARE 1 TIME-DEPENDENT RECORDINGS

ELEBD: ERROR AT POINT: 4

THE BOUNDARY POINT: 8086

DOES NOT BELONG TO ELEMENT : 0

POSSIBLE REASONS:

THE BOUNDARY CONDITION FILE IS NOT

RELEVANT TO THE GEOMETRY FILE

OR THE MESH HAS A WRONG TOPOLOGY


PLANTE: PROGRAM STOPPED AFTER AN ERROR

RETURNING EXIT CODE: 2

boundary point 8086 is not the node 8086...
2 2 2 0.000 0.000 0.000 0.000 2 0.000 0.000 0.000 20855 8086 #
so look 20855

Yes, that's true. Thank's.