Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
PRE/POST PROCESSORS
Blue Kenue
Can't set unit of imported shapefile
Flat Threaded
  • Page:
  • 1
  • 2

TOPIC: Can't set unit of imported shapefile

Can't set unit of imported shapefile 2 weeks 2 hours ago #44561

  • a.barton
  • a.barton's Avatar
  • OFFLINE
  • Moderator
  • Posts: 521
  • Thank you received: 138
Hi,

We're good :)

I'll release the next alpha with the WorkSpace saving/loading fixes. And then could you try again? And if you still encounter a problem then let us know.

Kindly,
Alan
The administrator has disabled public write access.

Can't set unit of imported shapefile 1 week 6 days ago #44581

  • a.barton
  • a.barton's Avatar
  • OFFLINE
  • Moderator
  • Posts: 521
  • Thank you received: 138
I just noticed your side note...
As a side note
I will note that "as specified" the mesher WILL take a LONG time to run.
You have asked for a final mesh that contains approximately 3.25 Million nodes. That's quite a lot.
It tooks 20 seconds (with a submesh and constraint lines) on 32core AMD Threadripper. That's impressive !

I'm assuming 20s was for 3.12.13-alpha. By any chance have you tried the same speed test with a previous version of BK, such as 3.3.4?

Kindly,
Alan
The administrator has disabled public write access.

Can't set unit of imported shapefile 2 days 7 hours ago #44659

  • nicogodet
  • nicogodet's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 127
  • Thank you received: 31
Seems fixed with 14-alpha !
The administrator has disabled public write access.
Flat Threaded
  • Page:
  • 1
  • 2
Moderators: Serrer, a.barton
Forum
PRE/POST PROCESSORS
Blue Kenue
Can't set unit of imported shapefile

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.