Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
PRE/POST PROCESSORS
Blue Kenue
errors when I do the step that interpolate the bathymetry to the mesh
Flat Threaded

TOPIC: errors when I do the step that interpolate the bathymetry to the mesh

errors when I do the step that interpolate the bathymetry to the mesh 6 years 2 weeks ago #29978

  • knightx202
  • knightx202's Avatar
hello,I am a newer for learning the telemac software,when I follow the tutorial [url=http://]http://www.opentelemac.org/index.php/component/jdownloads/summary/4-training-and-tutorials/185-telemac-2d-tutorial?Itemid=55[/url]
,before the section 3.4 ,the excecise results are all ok. but when I do the steps(section 3.4 interpolate bathymetry to mesh) ,then the result is not same with the turotial section 3.4.
My actual results is shown below the attach picture,which the elevation values are the same.

Although I have find the releated topic(maybe it could help me ) in the Bluekenue , I have not deal with the problem.
could anyone point out the problems where I am wrong?
Thank a lot.

Capture.jpg
The administrator has disabled public write access.

errors when I do the step that interpolate the bathymetry to the mesh 6 years 2 weeks ago #29979

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3632
  • Thank you received: 1010
Hi
Did you check the color scale and the data on your mesh after the interpolation?
Regards
Christophe
The administrator has disabled public write access.

errors when I do the step that interpolate the bathymetry to the mesh 6 years 2 weeks ago #29980

  • knightx202
  • knightx202's Avatar
Did you say the color scale of newmesh? I capture the picture shouwn below. the parameters needs to be modify？
Thank you！


Capture2.jpg


Capture3.jpg
The administrator has disabled public write access.

errors when I do the step that interpolate the bathymetry to the mesh 6 years 2 weeks ago #29983

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3632
  • Thank you received: 1010
Yes
Your color ramp is between 0 and 1 and the values between 6 and 38 so it's logical to see the mesh entirely in red!

reset the color scale and you will probably solve your problem

Regards
Christophe
The administrator has disabled public write access.
The following user(s) said Thank You: knightx202

errors when I do the step that interpolate the bathymetry to the mesh 6 years 2 weeks ago #29988

  • knightx202
  • knightx202's Avatar
It displays very well.
Thank you very much.
The administrator has disabled public write access.
Flat Threaded
Moderators: Serrer, a.barton
Forum
PRE/POST PROCESSORS
Blue Kenue
errors when I do the step that interpolate the bathymetry to the mesh

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.