TELEMAC-MASCARET Forum: mesh reading wrong (1/1)

Welcome, Guest

TOPIC: mesh reading wrong

mesh reading wrong 4 years 20 hours ago #38841

CAMERI_Shai
OFFLINE
Junior Boarder
Posts: 46
Thank you received: 4

Hi,

I'm having trouble with setting up a t3d case. I prepared the geometry and BC's in BK. The weird thing is, that the mesh in BK has 17572 nodes. But, when I run the simulation, the printout says that there are 426.
I didn't encounter such a problem when running any of the validation cases.

Any thoughts?

Cheers,
Shai

Attachments:

Ashdod_bot.slf (682KB)
BOTTOM_BC.cli (33KB)
t3d_source.cas (2KB)
out.log (35KB)

The administrator has disabled public write access.

mesh reading wrong 4 years 19 hours ago #38842

c.coulet OFFLINE Moderator Posts: 3799 Thank you received: 1056	Hi log file couldn't be opened. Change extension to txt
	Christophe The administrator has disabled public write access.

mesh reading wrong 4 years 18 hours ago #38843

CAMERI_Shai OFFLINE Junior Boarder Posts: 46 Thank you received: 4	sorry, I just saw the exception rule for file extensions. I tried the same simulation with 1 proc too. Now I'm not sure why the simulation crashed now, but I still suspect it has something to do with mesh and BC files. Attachments: out.txt (7KB)
	The administrator has disabled public write access.

mesh reading wrong 4 years 18 hours ago #38844

c.coulet OFFLINE Moderator Posts: 3799 Thank you received: 1056	The first remark about the number of nodes came from the parallel run as the listing just print the number of nodes of subdomain 0 ... The sequential run shows a problem with the definition planes for 3D. Look to the 3D repartition of planes ...
	Christophe The administrator has disabled public write access.

mesh reading wrong 4 years 18 hours ago #38845

CAMERI_Shai OFFLINE Junior Boarder Posts: 46 Thank you received: 4	Will do; much obliged. I'll update if I get it right.
	The administrator has disabled public write access.